User Manual

EN - 45
EN
electrician to substitute the socket with another suitable type.
• The plug and the socket must be conformed to the current norms of
the installation country.
• Connection to the power source can also be made by placing an
omnipolar breaker between the appliance and the power source
that can bear the maximum connected load and that is in line with
current legislation.
• The yellow-green earth cable should not be interrupted by the
breaker.
• The socket or omnipolar breaker used for the connection should
be easily accessible when the appliance is installed.
• The disconnection may be achieved by having the plug
accessible or by incorporating a switch in the fixed wiring in
accordance with the wiring rules.
• If the supply cord is damaged, it must be replaced by
Manufacturer, its service agent or similarly qualified people in
order to avoid a hazard.
• The earth conductor (yellow-green) must be longer than 10 mm
on the terminal block side. The internal conductors section should
be appropriate to the power absorbed by the hob (indicated on
the tag).
• The type of power cable must be H07RN-F.
• Do not put metallic objects such as knives, forks, spoons or lids
on the hob. They could heat up.
• Aluminum foil and plastic pans must not be placed on heating
zones.
• After every use, some cleaning of the hob is necessary to prevent
the build-up of dirt and grease.
• If left, this is recooked when the hob is used and burns giving
off smoke and unpleasant smells, not to mention the risks of fire
propagation.
• Never use a steam or high pressure spray to clean the appliance.
• Do not touch the heat zones during operation or for a while after use.
• Never cook food directly on the glass ceramic hob.
• Always use the appropriate cookware.
• Always place the pan in the center of the unit that you are
cooking on.
• Do not place anything on control panel.
• Do not use the hob as a working surface.
• Do not use the surface as a cutting board.