Operating instructions

Hair clipping

– The trimmer can be operated from the outlet with the adaptor connected (the battery

must be recharged partially) or only from the charged battery.

– The trimmer turns on and off with a switch A1. Turn the trimmer on only after all the

attachments have been properly placed and you are ready for trimming. Turn the trimmer

off immediately after use.

– Before you start clipping, make sure that the head of the person whose hair you are

cutting is at the same level as your chest so that all parts of his/ her head are clearly

visible and within easy reach.

– Only use the clipper on dry hair.

– Do not use on freshly washed hair.

– Before you begin, comb the hair in the direction of growth.

– To achieve optimal clipping results, always move the clipper slowly through the hair

against the direction of hair growth.

– When the battery power reaches minimum. It is a signal to charge the battery.

– In case an blades A4 gets blocked, the appliance must be turned off immediately and the

cause of the block removed.

Clipping with hair comb attachment

You may use 5 kinds of comb attachments B for trimming,

1) Put on the desired comb attachment (B1–B7). Then you can turn on the appliance.

2) If you are trimming for the first time, begin by trimming with an attachment of max. length

to prevent too short of a cut. When you have familiarized yourself with the settings, use

attachments B with lower length.

3) You may also use the blade cut length switch A5 for finer cut setting.

4) Make sure that the flat part of the comb is always in full contact with the scalp to obtain

an even result.

Move the clipper slowly over the crown from different directions to achieve an even result.

6) Always move the clipper against the direction of hair growth.

7) Make overlapping passes over the head to ensure that all hair that should be cut has

been cut.

8) Turn the Clipper off and remove the hair comb often to blow and/or shake out hair that

has accumulated.

Contouring without the hair clipping comb attachment

1) Remove the hair comb (if it is attached). Be careful when you are clipping without comb

attachment as when the clipper is turned on it will trim every hair it touches.

2) Tilt the clipper in such a way that only one edge of the trimming attachment touches the

hair ends when you shape the contours around the ears.

3) To contour the nape of the neck or hairline, turn the clipper and hold it with the trimming

attachment pointing downwards.

4) To contour the sideburns, turn the clipper and hold it with the trimming attachment

pointing downwards.

Note

You may also use the blade cut length switch A5 for finer cut setting.

19 / 33