Instructions

For a repeated analysis of body characteristics (after saving the input data of the person

to the memory – e.g. 1), proceed as follows:

1) Press the button (if you were using the scale in the regular weighing mode).

2) Wait for 0.0 on the display or choose the number of memory with the or button where

your setting is saved.

3) Do not press anything after selecting the respective number of memory (wait till 0.0 appears).

Step on the scale and your weight and bodily characteristics will begin to be analyzed.

Note

The scale is switched on automatically if you do not step on it within approx.

20 seconds after „0.0“ is displayed.

Error messages and their symbols

Symbols displayed Interpretation

LO Battery is dead

Err2

Very low % of fat

Very high % of fat

Err

The measured weight is higher than maximum allowed value of the

scale.

V. TROUBLESHOOTING OF POSSIBLE PROBLEMS

If you have problems with weight:

– Check whether the batteries are inserted properly.

– Check whether you selected the proper weight unit.

– Check whether the scale is on a flat floor and they do not touch the wall.

– If nothing appears on the scale when you want to switch them on by tapping on them

or if „

“ appears only, replace the battery.

– If „ “ appears on the display, the scale was overloaded.

– If unusual signs are displayed, remove the insert the battery again.

– If signs appear, such as if the display is flashing or if there is a faulty sign, try to move the

scale away from the influence of a source of interference or ensure switching off the source

for the time of using the scale.

VI. STORING

After using the scale, put it into the horizontal position (not vertically), out of reach

of children and incapacitated people (see par. I. SAFETY WARNINGS).

VII. MAINTENANCE

Do not use coarse and aggressive cleaning agents (e.g. sharp objects, scrapers, diluting

agents or other solvents). Clean the board by wiping with a soft wet cloth.

Make sure that water does not get inside the appliance.

24 / 51