Instructions

A) Regular weighing mode

Turn the scale on by stepping on the weighing surface. After a moment, the measured

weight flashes and the value remains displayed for several seconds. Then the scale are

switched off automatically.

B) Weighing and total body analysis mode

Setting (change) of personal data for the body fat and water analysis

Before the first analysis, it is necessary to put in personal data (sex, height and age) which

will be saved to the memory. It is possible to save data of 10 persons in the scale‘s memory.

The input data can be set and gradually changed in the following range:

Memory Gender Height Age

0 – 9 male / female

80 – 220 cm

2´07.5“ – 7´02.5“

6 - 100

1. Turn the scale on by stepping on the weighing surface (until will show 0.0).

2. Press the button Number of memory will start the flash on the display (e.g. 1).

3. Select the number of the memory (with button or ) to which you want to save the data

for the person to be weighed.

Confirm by pressing the button.

4. Set your sex with the or button:

male / female

Confirm by pressing the button.

5. Set your height with the or button.

Confirm by pressing the button.

6. Set your age with the or button (Age)

Confirm by pressing the button.

Now all the personal data is saved (changed). Wait till 0.0 appears. Stand on the scale

and wait for results.

The following data will start to show after a few seconds:

1. – Weight in set units

2. – Body fat contents in % (fat)

3. – Body water contents in % (TBW)

4. – Musculature contents in % ( )

5. – Bone weight contents in kg ( )

6. – Daily kilocalorie requirement (KCAL)

– BMI (Body Mass Index)

The results will display in a cycle. After three repetitions, the scale will automatically turn off.

Notice

There must not be a contact between feet, calves or thighs. Otherwise the measurement

could be inaccurate.

/ 51