Instruction Manual

How to assemble the accessories
Extension hose B1
Can be attached to the steam nozzle A4 by putting it on and rotating clockwise (identically
to Fig. 2). Apply a reverse procedure to remove, but first press the shifting safety catch of
the lock – see Fig. 4.
Concentrating nozzle B2
Can be attached to the steam nozzle A4 or extension hose B1 by putting it on and rotating
clockwise (Fig. 2 and 3). Apply a reverse procedure to remove.
Accessories B3-B8
Can be attached to the concentrating nozzle B2 by putting it on and rotating clockwise
(see Fig. 5). Apply a reverse procedure to remove.
Water filling/adding
When filling the water before use, make sure that the appliance is not connected to the
mains. Unscrew the safety pressure valve A3 by rotating it anti-clockwise. Slowly fill the
inside tank with water, using the enclosed container C for water replenishing. Do not
exceed the maximum permitted volume of water (i.e. 220 ml). Apply reverse procedure to
properly screw the safety pressure valve A3 in, and tighten it using a reasonable force.
When replenishing water during operation, it is first necessary to eliminate the internal
pressure inside the water tank. Disconnect the power cord from the mains and release
the residual pressure, until steam stops coming out, and the safety catch A8 fits in (or it
can be pushed inside the valve quite easily). Let the appliance cool down for at least 5
minutes, and then unscrew the safety pressure valve. Pour water in the open appliance,
and screw the valve in place.
Attention
– Release of the excessive pressure and the appliance cool down are important steps,
because the pressure and the temperature in the tank are high also after disconnecting
the appliance from the mains. This means if you pour cold water inside the hot tank
immediately after opening it, there is a risk of scalding from evaporation of the added
water.
IV. STEAM CLEANER USE
The appliance becomes active and starts heating the water in the tank once you connect
it to the mains. Connection to the mains and tank water heating is indicated by the red
operation indicator light A5. Steam will be ready for cleaning in about 2-3 minutes.
The ready status is indicated by turning off the indicator light A5.
To activate the steam, you must first move the safety catch A2 preventing unwanted
on-switching, and then press the steam release button A1.
Once you see a significant decrease in the volume of the produced steam, the water tank
must be replenished (see “Water filling/adding”).
24
EN
/ 52