Instructions

The following data will start to show after a few seconds:

1. – Weight in set units

2. – Body fat contents in % (fat) + analysis colour signalization (blue=underweight;

green=normal; red=overfat, obesity)

3. – Body water contents in % (TBW)

4. – Musculature contents in % (

)

5. – Bone weight contents in kg ( )

– BMI (Body Mass Index)

7. – Daily kilocalorie requirement (KCAL)

The results will display in a cycle. After three repetitions, the scale will automatically turn off.

Notice

There must not be a contact between feet, calves or thighs. Otherwise the measurement

could be inaccurate.

For a repeated analysis of body characteristics (after saving the input data of the person

to the memory – e.g. 1), proceed as follows:

1) Press the button (if you were using the scale in the regular weighing mode).

2) Wait for 0.0 on the display or choose the number of memory with the or button

where your setting is saved.

3) Do not press anything after selecting the respective number of memory (wait till 0.0

appears). Step on the scale and your weight and bodily characteristics will begin to be

analyzed.

Note

The scale is switched on automatically if you do not step on it within approx.

10 seconds after „0.0“ is displayed. The scales can be turned off also by pressing the

button .

Error messages and their symbols

Symbols displayed Interpretation

LO Battery is dead

Err2

Very low % of fat

Very high % of fat

Err

The measured weight is higher than maximum allowed value

of the scale.

V. TROUBLESHOOTING OF POSSIBLE PROBLEMS

If you have problems with weight:

– Check whether the batteries are inserted properly.

– Check whether you selected the proper weight unit.

– Check whether the scale is on a flat floor and they do not touch the wall.

– If nothing appears on the scale when you want to switch them on by tapping on them

or if „Lo“ appears only, replace the battery.

24 / 51