User's Manual

– 6 – ETAsys.com
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
FRONT PANEL FEATURES
1. Unswitched AC Outlet – The 120VAC outlet is always live when the ETA-PD8 power cord is plugged into an AC mains power
source and voltage is present. Note: The AC mains power switch does not affect the Unswitched AC Outlet. The Unswitched
Outlet is protected by the surge protection circuitry.
2. AC Mains Breaker – The 15A rated breaker will open if the combined draw of all AC outlets exceeds 15A. Note: The breaker is
designed to exceed its rating for a short period of time. If the breaker is tripped, you must first remove the load from the ETA-PD8
and then push to reset.
3. Power Switch – To turn the ETA-PD8 on or off, press the switch to the ON or OFF position. The power switch will illuminate
when in the “On” position.
REAR PANEL FEATURES
1. AC Mains Input – Connect the 9' (3m) power cord to a 15A 120VAC outlet to provide power to the ETA-PD8.
2. AC Switched Power Outlets – These six outlets are “Live” when the front panel power switch is activated.
3. AC Unswitched Power Outlets – These two outlets are always “Live” when the ETA-PD8 is plugged into a 120VAC source.
Installation
Before installing, we strongly suggest you read the entire manual to ensure you benefit from all the features of the ETA-PD8. The
ETA-PD8 can be placed on a shelf or rack mounted in a standard 19" width rack. When rack mounting, use Rack Rail type screws which
are
10
⁄32" x 1" When rack mounted, placement within the rack is flexible however the ETA-PD8 should be within 6' of a dedicated 15A
AC outlet. Always make sure the 15A outlet is properly inspected by a certified electrician prior to connecting the ETA-PD8. Make sure
to inspect the equipment that is to be plugged into the ETA-PD8 to ensure it does not exceed 15A total amperage draw.
ETA-PD8
Power Conditioner & Distribution Unit
1 2 3
12 3