User Guide

DÈPANNAGE
Luminaire introuvable sur le
réseau
Luminaire pourrait ne pas être au mode de
connectivité
Problème de câblage
Pas d'électricité
Réseau non connecté
Luminaire n'est pas jumelé correctement
Permissions non accordées sur l'apparei mobile
Mot de passe WiFi incorrect
Signal WiFi faible
WiFi non connecté
Relisez les instructions d'INSTALLATION et confirmez.
Assurez-vous que l'interrupteur connecté et le disjoncteur du circuit sont sous tension.
Vérifiez la connectivité au réseau sans fil.
Actionnez l'interrupteur connecté au luminaire cinq fois (ALLUMÉ/ÉTEINT) pour passer au
Mode de Jumelage.
Assurez-vous que les permissions sont accordées à l'appli WiZ.
Saisissez le mot de passe WiFi de nouveau.
Assurez-vous d'être en-deça de la portée du répartiteur.
Assurez-vous que le répartiteur WiFi émet un signal de 2,4 GHz. Reconnectez-vous.
Impossible d'actionner luminaire
avec l'interrupteur connecté
Luminaire ne réagit pas à une
commande de l'appli WiZ
Luminaire ne se connecte pas à
l'appli WiZ
Actionnez l'interrupteur connecté au luminaire trois fois (ALLUMÉ/ÉTEINT) pour
passer au Mode de Jumelage.
PROBLÈME CAUSE SOLUTION
APPAIRAGE DE PRODUITS
NOTE: Apres la première installation, veuillez patienter 1 minute avant chaque mise à jour
www.liteline.com/WiZsupport
Créer un domicile
Joindre un domicile
Nommez votre
Domicile
Ajoutez vos
pièces
Choisissez votre
pièce
Ajouter vos
appareils
Sélectionnez ‘Type of
device’ et suivez
les instructions
Pour plus d’aide, veuillez contacter Wiz Support à l’aide du lien suivant
NOTE: L’application WiZ DOIT OBLIGATOIREMENT ÉTRE CONNECTÉE A UN RÉSEAU Wi-Fi
2.4Gz afin de synchroniser vos luminaires.
Assurez vous d’installer votre luminaire correctement avant de le synchroniser. Téléchargez
l’application WiZ depuis Google Play ou sur l’App Store. (SI VOTRE LUMINAIRE N’EST PAS
ENCORE INSTALLÉ, REFERREZ VOUS AUX INSTRUCTIONS EN DÉBUT DE SECTION SOUS
LA RUBRIQUE “INSTRUCTIONS D’ASSEMBLAGE”).
Téléchargez
l’application
Installez votre
luminaire
Synchronisez votre
nouveau luminaire
ETAPE 1
TÉLÉCHARGER L’APPLICATION WiZ
FR
The following importer is the responsible party:
LLC Sales, Inc. DBA Liteline USA
1209 Orange Street, Wilmington, DE, 19801
Liteline.com/contact-us
Note: This equipment has been tested to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures: (1) reorient or relocate the
receiving antenna; (2) increase the separation between the equipment and receiver; (3) connect the
equipment into an outlet on a circuit different from that to which the receiver is connected; consult the
dealer or an experienced radio/TV technician for help.
RF Exposure Requirements:
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter and must be installed to provide a separation distance of at least 20cm
from all persons.
ISED Canada Compliance Statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence exempt RSS(s). Operation is subject to the following two
conditions: (1) This device may not cause interference; and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
Déclaration de Conformité ISDE Canada
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d'Innovation, Sciences et Développement Économique Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) L'appareil ne doit pas
produire de brouillage; et (2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
recieved, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the resposible party could void the user’s authority
to operate the equipment.