Owner's Manual
18
ENGLISH
ELECTRICAL INTERCONNECTION
+12V
Connect the 12 volt terminals of the amplier to the positive poles of the power capacitors by using
suitable cables. Then connect the positive poles of the power capacitors to the 12 volt positive pole
of the additional battery.
ATTENTION: Use for both connections sufciently dimensioned cables of at least Ø 50 mm
2
with
a total length of max. 1.5 meters. If you use longer cables, the cross-section must be correspond-
ingly larger. Use very short cable lengths from the amplier to the power capacitors, which should be
mounted close as possible to the amplier.
1
BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure
a sufcient prole section and a suitable fuse rating and the conductivity of the cables when you purchase
your wiring kit. Clean and remove rust-streaked and oxidized areas on the contact points of the battery and the
ground connection. Make sure that all screws are xed tight after the installation, because loose connections
cause malfunctions, insufcient power supply or interferences.
Not included in the scope of delivery
< 30 cm >
Turn-on cable to the head
unit (car radio)
ADDITIONAL
BATTERY
< 15 cm >
< 15 cm >
1 2 3
6
6
5
4
4
< 30 cm >
Min. Ø 50 mm
2
with a
max. total length of 1.5 m
Min. Ø 50 mm
2
with a
max. total length of 1.5 m
Min. Ø 50 mm
2
with a
max. total length of 1.5 m
Min. Ø 50 mm
2
with a
max. total length of 1.5 m