Owner's Manual
18
ENGLISH
ELECTRICAL INTERCONNECTION
+12V
Connect the 12 volt terminal of the amplier to the positive pole of the power capacitor by using a suit-
able cable (refer to the table on the next page). Then connect the positive pole of the power capacitor
to the 12 volt positive pole of the vehicle battery.
ATTENTION: Use for the connection a sufciently dimensioned cable of at least Ø 25 mm
2
with a total
length of max. 2 meters. If you use a longer cable, the cross-section must be correspondingly larger.
Use a very short cable length from the amplier to the power capacitor, which should be mounted
close as possible to the amplier.
1
REM
Connect the turn-on signal from the head unit / car radio (REM) with the REM terminal of the power
capacitor. Then connect the REM terminal of the power capacitor with the REM terminal of the ampli-
er. Hereby the amplier and the power capacitor are turning on or off with the head unit / car radio.
Use therefor a suitable cable with a sufcient cross section (0,5 mm
2
).
BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure
a sufcient prole section (refer to the table on the next page) and a suitable fuse rating and the conductivity
of the cables when you purchase your wiring kit. Clean and remove rust-streaked and oxidized areas on the
contact points of the battery and the ground connection. Make sure that all screws are xed tight after the instal-
lation, because loose connections cause malfunctions, insufcient power supply or interferences.
2
1 2 3
< 30 cm >
Turn-on cable to the
head unit (car radio)
Min. Ø 25 mm
2
with a
max. total length of 2.0 m
Min. Ø 25 mm
2
with a
max. total length of 2.0 m
VEHICLE
BATTERY
< 15 cm >
4
5 6