manual

ESTOS CallControlGateway 4.0.0.21648
6
All components are optimized for the power of 64 bit versions and fulfil Windows Vista security
standards.
1.1 Installation notes
This document is related to the Microsoft Office Communications Server 2007
(OCS) and the Microsoft Live Communications Server 2005 SP1 (LCS). If not
otherwise stated, the documentation is valid for both products.
When installing the ESTOS CallControlGateway, please note the following order:
1. Lync Server, Office Communications Server or Live Communications Server
Before you start the installation, you should already have a Microsoft Lync Server, OCS or Live
Communications Server installed.
2. Installation of the Tapi driver for your PBX system
First install the Tapi Driver for your PBX system on the server. This driver makes available all
extensions of your PBX system as Tapi line devices.
At ESTOS we offer you Tapi Drivers for many PBX systems. These ECSTA Tapi Drivers are
recommended as the best solution for the ESTOS CallControlGateway.
Most manufacturers of PBX systems offer Tapi Drivers. An overview of supported TK-Systems can be
found under TK-System.
3. Preparation for installation
It is strictly recommended to use either a separate CTI server computer, or to setup an additional IP
Address on an existing server.
You can set up an additional IP address at the properties of your Network connections. There you can
add an IP address under IP address (DHCP must be switched off).
4. Installation of ESTOS CallControlGateway
Run the MSI setup. During the setup, a wizard helps you with the initial configuration of the server.
o See Installation of the ESTOS CallControlGateway
5. Configure Lync Server, Office Communications Server or Live Communications Server
The ESTOS CallControlGateway must be configured as a static route in the Lync Server, OCS or Live
Communications Server.
o See Configure Lync Server.
o See Configure Live Communications Server.
o See Configure Office Communications Server.
6. Configure Lync client or Office Communicator
To use the telephone integration, the ESTOS CallControlGateway and the telephone number of the
telephone must be configured for each user.
o See Configure Lync Client.
o See Configure Office Communicator 2005.
o See Configure Office Communicator 2007.
7. Functional Test
Check if the configuration is correct.
o See Checklist Functional Test.