manual
ESTOS CallControlGateway 4.0.0.21648
48
ESTOS CallControlGateway will only use the international numbering plan for
all phone numbers.
Supercanonical phone numbers always begin with a + and have the following
format: +Country Area Number
But no spaces are used. e.g. +49301234567
Phone number should only contain numbers and +.
Service numbers
are special public phone numbers which cannot be given in international
number format. These are for example emergency numbers (110) or directory
enquiries (118xx). In order to be able to dial these numbers from a PC they
must either be longer than the internal phone numbers or configured as
external rules. these numbers are specified directly as dialable numbers:
Phone number
No spaces are used. Example: 11833
Dialable phone numbers
are always kept in the format required by the phone system in order to reach the subscriber. The
number is formatted according to the rules in ESTOS UCServer.
Examples:
Phone number internal extension number
Phone number external dialing code Number of subscriber 12345 in the local area network
External dialing code Country Area code Phone number Number of a subscriber in a different
country
The above examples apply for Germany and depends to a large extent on the country. You can see
which dialing rules apply for your location in the location settings.
7.7 Instructions for installation with Microsoft Installer
This chapter contains general information concerning Microsoft Installer is not
directly related to the product.
Installation on a terminal server
The following points should be borne in mind when running msi on a Terminal
Server:
Administrators and non-administrators can run Windows Installer Installations from the
command line.
A terminal server remote session allows only administrators to perform installations.
Administrators can only perform Windows Installer installations from a remote session if
the EnableAdminTSRemote system policy is activated. This policy is only available from
Windows Installer version 1.1 upwards and Windows 2000 and later Windows versions.
The Windows Installer is started as a system service and therefore cannot access connected
network drives. If you execute msi from a network resource, use UNC paths
(\\Server\Verzeichnis\produkt.msi).
If you are experiencing Installer Error 2755: Server returned unexpected error 3 attempting
to install package, it is most likely that you executed setup from a network drive and did not
use UNC paths (installer service is unable to find msi).
7.8 Operating system requirements
Depending on the operating system, different components are needed which
must be present before installation starts. This list only includes Windows