manual

ESTOS CallControlGateway 4.0.0.21648
11
o Replace Host in requirement-URI: switched off
6. Change now to the Host authorization tab. Click on add.
7. Enter the following information:
Server
o IP Address: e.g. 192.168.2.50
Enter the same IP address used under Routing here. Enter an IP address and not a
network address.
Settings
o Outgoing only: on
o Restrict server: switched on
o Treat as authenticated: switched on
8. Click on OK, on apply and then on OK.
Note that the settings for static routes may not take effect until you restart the
OCS .
3.2 Static Route for TLS
For the TLS communication you must use a Network address (FQDN) in the
static route.
Add a static route for the ESTOS CallControlGateway
1. Register with the Office Communications Server 2007 Server as a member of the
RTCUniversalServerAdminsgroup.
2. Start the Office Communications Server-Administration-Snap-In.
3. Extend the total structure node.
1. For an Enterprise Pool: extend the pool, click with the right mouse key on Front
Ends and click Properties.
2. For a Standard Edition Server: Extend Standard Edition Servers, click with the right
mouse key on the pool, click Porperties and click then Front End Properties.
4. Click add on the Routing tab.
5. Enter the following information:
Matching URI (Uniform Resource Identifier)
o Domain: callcontrol.yourdomain.com
o Phone URI: off
Next hop
o Network address: e.g. ctiserver.yourdomain.com
Enter the network address of the computer on which the ESTOS CallControlGateway
offers its services here. The network address needs to match with the FQDN Server
certificates.
o Transport: TLS
o Port: 5071
This is the standard port of the ESTOS CallControlGateway. If another port was used
in the ESTOS CallControlGateway configuration, enter this port.
o Replace Host in requirement-URI: switched off
o Select a valid certificate for the Mutual TLS encryption.
6. Change now to the Host authorization tab. Click on add.
7. Enter the following information:
Server
o Network address: e.g. ctiserver.yourdomain.com
Enter the same network address used under Routing here. A network address has to
be entered.
Settings
o Outgoing only: on
o Restrict server: switched on
o Treat as authenticated: switched on
8. Click on OK, on apply and then on OK.