Users Manual

Battery Pack

The MD-100 device has one small, permanent, internal battery and one hot-swappable battery. When

hot swappable battery has low voltage and needs to be replaced, the built-in battery will power the

tablet for up to 10 minutes.

To charge the Battery Pack:

1. Connect the power cable to the charging port on the device.

2. Connect the power adapter to an electrical outlet and charge the tablet until the battery is

fully charged.

3. After your device is fully charged, disconnect the charger from both the device and the

electrical outlet.

4. Additional hot-swappable batteries can be charged independently of the Tablet PC by

placing the battery into a docking station with a battery charging bay (available separately).

NOTE: To prevent damage to batteries, please see Section 8: Safety

Battery life naturally degrades over time. Failure to follow instructions for recommended

operating temperatures, charge and discharge rates, and other instructions may accelerate

battery decay rates. If your tablet battery will not accept or hold a satisfactory charge, it may need

to be replaced.

For battery storage and charging temperatures, see Section 8: Safety

Checking the Battery Level

To check the battery charge level of the MD-100, you may use the battery monitor within Windows

operating system or the voltage gauge of hot swappable battery pack.

When the hot swappable battery pack is not installed in the Tablet PC and you want to know the battery

level, press the Battery Test (1) button. The gauge will display the current battery charge level.

Any battery level indication is an estimated result. The actual operating time can be different from the

estimated time, depending on how you are using the Tablet PC.