User`s manual

CHAPTER 1
STARTING OUT
1-2
BEFORE YOU START
Congratulations on your purchase of the ESTeem
Wireless Modem! This section of the manual will
describe the basic functioning and programming of the
ESTeem to get your wireless network up as soon as
possible. It is recommended that any first time user of
the ESTeem and those that are unfamiliar with its
operation complete all steps in this section before
proceeding.
Take a few minutes to inventory your equipment before
you proceed. Report any missing or damaged items to
Customer Support as soon as possible. We at Electronic
Systems Technology, Inc. (EST) are constantly trying to
improve our products and support system so if you have
any comments or suggestions on improvement of this
manual, please contact us at [phone].
The completion of this section requires loading the
ESTeem Utility program on your computer. The
following section will describe the installation and use of
this valuable utility program.
ESTEEM UTILITY
The ESTeem Utility is designed to assist the ESTeem
user in programming and troubleshooting. The Utility
covers basic operation, programming, PLC applications,
and diagnostics of the ESTeem.
Installing ESTeem Utility Software-DOS
1. Boot-up the computer using DOS.
2. Insert the 3.5 inch ESTeem Utility Program into
drive A. Reference Figure 1.
3. Select drive A from DOS by typing A: and press
RETURN.
4. Type INSTALL followed by pressing RETURN.
5. The ESTeem Utility and Diagnostic Programs will
be loaded on to your computer's hard drive.
Installing ESTeem Utility Software-WINDOWS
1. Insert the ESTeem Utilities Disk in drive A, or type
the appropriate drive for your system.
2. Select RUN from the File menu.
3. Type A:\install on the RUN line.
4. Follow the procedures in the installation program.
5. Remove the ESTeem Utility Program from drive A
and store in a safe place.
Running The Program
1. To run the program, type EST-U followed by a
RETURN. Figure 2 shows an example of the menu
of the ESTeem Utility program. If you see this
menu, you have successfully completed the
installation of the ESTeem Utility software.
ELECTRONIC
TECHNOLOGY, INC.
SYSTEMS
WIRELESS MODEM COMMAND CENTER
Terminal Emulation
ESTeem Setup
ESTeem Programming
PLC Applications
ESTeem Diagnosic Programs
Product Information
About
Quit
Use to manually progam
or configure your
ESTeem modem with the
computer
Figure 2: ESTeem Utility Main Menu
TNC Male
Connector
12 VDC Power Supply
(EST P/N AA174)
2 Pin Molex
Connector
RS-232C Interface Cable
(EST P/N AA061)
Magnetic Mount Antenna
ESTeemUtility Software
(EST P/N AA11)
ESTeem Rear View
ESTeem
Utilities
ELECTRONIC SYSTEMS
TECHNOLOGY INC.
Figure 1: Installation Diagram