User`s manual

APPENDIX D
SOFTWARE COMMANDS
APX D-8
SAve (1-2)
The save command. The execution of this command stores the
current command values and switches to one of two different
nonvolatile memories. The commands are SAVE ( 1 = default value)
and SAVE 2. NOTE: Please wait approximately two seconds after
executing the SAVE command before turning off power to the
ESTeem.
SDLC (on/off)
The Synchronous Data Link Control (SDLC) command.
ON: When enabled, this switch configures the ESTeem modem
RS-232C port for transparent SDLC mode. This mode will be
executed when the SDLC command has been invoked,
SAVED, bit 8 of the RS-232C switched ON, and the modem
hardware reset.
OFF: The ESTeem modem RS-232C port is configured as an
asynchronous character port.
Factory default = OFF.
SECURIty (on/off)
The security command: When enabled you can input a security
code from 0 to 65535.
ON: Prevents protected commands from being modified.
Factory default = OFF.
SENDPAC (0-255)
The send packet command. The value specifies an ASCII character
used to signal when to send the packet. The send packet factory
default value is 13 (Carriage Return <cr>).
SETCon (r1,r2,r3,da)
This command defines the destination address for the ESTeem to
perform a connect using the Auto Connect feature. This function
supports a direct connect or a connect through a maximum of three
repeaters.
r1 = ESTeem address (0 to 253) of repeater 1.
r2 = ESTeem address (0 to 253) of repeater 2.
r3 = ESTeem address (0 to 253) of repeater 3.
da = Destination address (0 to 255).
SETMode (on/off)
The TRANSPARENT mode set command.
ON: When switch #8 of the RS-232C Set-up switch on the rear of
the ESTeem is set ON, the SET Mode is ON, and the ESTeem
is reset (a reset reads in the position of the switch #8 after it
was changed), the ESTeem will enter Auto-Connect
TRANSPARENT mode. COMMAND and SENDP character
are defeated.
OFF: When switch #8 of the RS-232C Set-up switch on the
rear of the ESTeem is set OFF. The modem will no
longer auto-connect in the transparent mode on receipt of
data.
Factory default = OFF.
SETTrans (on/off)
This command is used to enable/disable the following commands for
TRANSPARENT MODE using one input command:
ON: AUTOLF = OFF PROMPT = OFF
ECHO = OFF TYPSYSTE = OFF
EDIT = OFF
OFF: AUTOLF = ON PROMPT = ON
ECHO = ON TYPSYSE = ON
EDIT = ON
Factory default = OFF.
SQDCTRL (on/off)
This function enables the Square D controller protocol. For further
detail Reference the EST Engineering Report on Square D controller
interfacing.
Factory default = OFF.
SQDADD (0-255)
This function is used with the SQDCTRL command to control the
address fence when using SQ-D Network Interface Modules. For
further details reference the EST Engineering Report on the SQ-D
controller. Factory default = 0.
STArt (0-255)
The start command for flow control. The value specifies the ASCII
character used to start XSFLOW.
Factory default = 17 [CTRL Q].
STOp (on/off)
The stop command for flow control. The value specifies the ASCII
character used to stop XSFLOW.
Factory default = 19 [CTRL S].