User`s manual

APPENDIX C
TABLES/DIAGRAMS
APX C-8
HAYES MODEM COMMAND TABLE
Listed Below are the definitions of the Hayes Modem Commands in alphabetical order:
AT
Hayes command for checking the status of the modem. It will return the
"OK" prompt if HAYES ON software switch is enabled.
AT&H (0-3)
Hayes command that defines the flow control as follows:
0 = Disables both XHFLOW and XSFLOW.
1 = Enables XHFLOW and disables XSFLOW.
2 = Enables XSFLOW and disables XHFLOW.
3 = Enables XHFLOW and XSFLOW.
ATD (0-255)
Hayes command to initiate a connect packet to a destination node. A
value from 0 to 255 can be assigned. Factory default is 2.
ATDP (0-255)
Hayes command to initiate a connect packet to a destination node. A
value from 0 to 255 can be assigned. Factory default is 2.
ATDT (0-255)
Hayes command to initiate a connect packet to a destination node. A
value from 0 to 255 can be assigned. Factory default is 2.
ATE (0-1)
Hayes command with a range of 0 to 1 that defines the ECHO
parameter as follows:
0 = Disables ECHO.
1 = Enables ECHO.
ATQ (0-1)
Hayes command with a range of 0 to 1 that defines the TYPSYSTE
parameter as follows:
0 = Enables TYPSTSTE.
1 = Disables TYPSTSTE.
ATS (r,n)
Hayes command for configuring its internal registers. ESTeem only
supports register 2 which defines the escape character value. (r = n).
r = Hayes specified register value.
n = Hayes register value range of 0 to 255 that defines the
Escape character value.
ATV (0-1)
Hayes command with a range of 0 to 1 that defines the MESSFORM
parameter.
0 = Enables MESSFORM.
1 = Disables MESSFORM.
ATX (0-6)
Hayes command with a range of 0 to 6 that defines the Extended set
variable. Factory default is 0.
ATZ
Hayes command to execute a RESTORE command.