User`s manual

APPENDIX C
TABLES/DIAGRAMS
APX C-7
HAYES MODEM MESSAGES TABLE
Listed below are the Hayes Modem Messages and their definitions. To receive these messages, TYPSYSTEM must be ON (See Appendix E,
Definitions). All Hayes Modem Messages have a bell (07H or CTRL G) preceding the message except when MESSFORM is ON. If MESSFORM
= OFF line A will be displayed. If MESSFORM = ON line B will be displayed.
1. A "OK"
B0
This message is displayed when the ESTeem recognizes the
"AT" <cr> followed by a carriage return.
2. A "CONNECT"
B1
This message is displayed when the ESTeem has completed a
valid link.
3. A "RING"
B2
This message is not applicable in regards to the ESTeem modem
operation.
4. A "NO CARRIER"
B3
This message is displayed when the ESTeem has lost a valid link
(failed to connect).
5. A "ERROR"
B4
This message is not applicable in regards to the ESTeem modem
operation.
6. A "Connect 1200"
B5
This message is displayed when the link has been established,
the baud rate select switch of the ESTeem has been read and is
verified be set at 1200, and the AT command has been received
where X>0.
7. A "NO DIAL TONE"
B6
This message is not applicable in regards to the ESTeem modem
operation.
8. A "BUSY"
B7
This message is displayed when the ATX command has been
received by the ESTeem bs X>2.
9. A "NO ANSWER"
B8
This message is displayed when the ATX command has been
received by the ESTeem and X>2.
10. A "RESERVED"
B9
This message is not applicable in regards to the ESTeem modem
operation.
11. A "CONNECT 2400"
B10
This message is displayed when the link has been established,
the baud rate select switch of the ESTeem has been read and is
verified to be set at 2400, and the ATx command has been
received where X>0.
12. A "RINGING"
B11
This message is not applicable in regards to the ESTeem modem
operation.
13. A "VOICE"
B12
This message is not applicable in regards to the ESTeem modem
operation.