User`s manual

APPENDIX C
TABLES/DIAGRAMS
APX C-5
ESTEEM SYSTEM STATUS MESSAGE TABLE (continued)
32. A "USING FACTORY DEFAULTS"
B SS32
This command states when factory defaults have been
enabled.
33. A "NEW SOFTWARE VERSION"
B SS33
This message will appear when new EPROM version has been
installed in the modem.
34. A "NOVRAM CURRENTLY IS BLANK!"
B SS34
This command states when the modem has tried to boot from
blank novram.
35. A "ANOTHER PLC COMMAND ALREADY ENABLED"
B SS35
This message is displayed when one of the PLC commands
(Square D, Westinghouse, or Johnson Controls) is enabled
and one of the other PLC commands is requested.
36. A "DISABLED DUE TO MODECNTL COMMAND"
B SS36
This message is displayed when the MODECNTL command is
enabled, and the CONVERSE command is issued from the
keyboard.
37. A "HAYES PROTOCOL NOT ENABLED"
B SS37
This message is displayed when any HAYES command is
invoked and HAYES is OFF.
38. A "DISABLED DUE TO RTS CTS COMMAND"
B SS38
This message is displayed when the RTS CTS command is
enabled and the XHFLOW command is invoked.
39. A "DISABLED DUE TO XHFLOW COMMAND"
B SS39
This message is displayed when the XHFLOW command is
enabled and the RTS CTS command is invoked.
40. A "REMOTE PROGRAMMING"
B SS40
This message is displayed when the ESTeem has been placed
in the remote programming mode.
41. A "REMOTE PROGRAMMING REJECTED!"
B SS41
This message is displayed when an ESTeem is unable to
remote program another unit.