User`s manual
APPENDIX C
TABLES/DIAGRAMS
APX C-4
ESTEEM SYSTEM STATUS MESSAGE TABLE (continued)
15. A "ENABLING SECURITY!"
B SS15
This is displayed for a correct entry to Enter Security value
from the command Security On.
16. A "DISABLING SECURITY!"
B SS16
This response is displayed when a correct security value is
entered from the command Security Off.
17. A "INVALID SECURITY VALUE!"
B SS17
This is displayed when a value other than the one used to
enable the security is used to disable the feature.
18. A "EDIT IS ALREADY ENABLED"
B SS18
This message is displayed when Block Mode is enabled and the Edit
Function is already turned off.
19. A "TERMCONT IS ALREADY ENABLED"
B SS19
This message is displayed when Block Mode is enabled and
the TERMCONT timer is already enabled.
2O. A "MODEM CONFIGURED AS A PACKET MONITOR"
B SS2O
This message is displayed when the modem is configured in
the monitor mode.
21. A "ADDRESS USED AS DESTINATION"
B SS21
This message is displayed when operator tries to set the unit
address of the modem equal to the destination address.
22. A "PACKET RESPONSE BUFFER OVERFLOW"
B SS22
An internal buffer has been added to hold up to seven pending
packet responses. If the modem is unable to clear its buffer
before the eight message is received then following message
will be displayed.
23. A "INVALID REPEATER ADDRESS"
B SS23
This message is displayed when trying to use ADDRESS 255
as a repeater address.
24. A "NODE CONNECT ATTEMPTS WERE "XX"
B SS24
This message will tell the user the number of attempts to
connect to your unit when you are connected to another
modem. The buffer will hold a maximum of five (5)
addresses. If more than five attempts are made a "CONNECT
ATTEMPTS BUFFER OVERFLOW" will be printed after the
number of attempts. This message will be displayed when you
return to the COMMAND MODE. See NODES in the
COMMAND TABLE.
25. A "CONNECT ATTEMPTS BUFFER OVERFLOW"
B SS25
This message will be displayed if more than five attempts were
made to connect to your unit. See Item 24.
26. A "NO NODES ATTEMPTED CONNECT!"
B SS26
This message will appear if NODES is executed from
COMMAND MODE and no addresses are in the memory
buffer. See NODES in the COMMAND TABLE.
27. A "FAILED TO CONNECT!"
B SS27
This message occurs if the modem fails to connect.
28. A "FAILED TO DISCONNECT!"
B SS28
This message occurs if the modems are connected and are
unable to disconnect.
29. A "ENTER ROUTE #"
B SS29
This prompt is enabled when the ALTEROUT command is ON
and asks the user for up to four different routes.
30. A "ENTER POLE ADDRESS #"
B SS30
This prompt is enabled when the A_BADD command is on and
asks the user for the address of the device connected to the
ESTeem. Reference Allen-Bradley Engineering Report
90-023.
31. A "INVALID POLE ADDRESS!"
B SS31
This message is displayed when an invalid pole address is
entered.