User`s manual

CHAPTER 6
ANTENNAS
6-10
ESTeem SWR Measurement Block Diagram
Programming The ESTeem For SWR Measurements
1. Configure the hardware as per the above diagram.
2. Turn Switch 8 on the RS-232 Setup Switch (located on
the rear of the ESTeem) to the OFF position.
3. Reset the ESTeem (front panel switch).
4. Install the ESTeem Utility on the PC hard drive as per
instructions with the software.
5. From Utility Main Menu (Figure 1) select the Terminal
Emulation Mode.
6. In the Terminal Emulation Mode type the following
commands followed by a RETURN.
FA Return This returns the unit to factory
default parameters.
RAD ON Return Enable the RADIO ON command.
The transmitter will alternate ON
for 10 seconds and OFF for 3
seconds.
7. When the testing is completed, type the following:
RAD OFF Return This disables the RADIO ON command.
ESTeem Utilities
Electronic
Systems
Technology
UHF Male
Connector
UHF Male
Connector
TNC Male
Connector
Antenna
2 Pin Molex
Connector
RS-232C Interface Cable
(EST P/N AA061)
UHF Male
Connector
Note:
Use a UHF Male to
N-Female Adapter if
attachin
g
to a feedline
with a male N connector.
SWR Meter
(Bird Model 43
or equivalent)
RG-8 Cable
(EST P/N AA233)
12 VDC Power Supply
(EST P/N AA174)
Electronic
Systems
Technology Inc.
WIRELESS MODEM COMMAND CENTER
Terminal Emulation
ESTeem/Setup Programming
PLC Applications
ESTeem Diagnostic Programs
Product Information
Site Survey Information
About
Quit
Use to manually program or
communicate to your ESTeem
modem with this computer.