User`s manual

CHAPTER 6
ANTENNAS
6-5
Model 95 Indoor Antenna Setup Diagram
PHO NE
ANTENNA
PO WER
12 V DC
RS-232/422/485 INTERFACESETUP SWI TCH
192C 00001S/ N:
ELECTRONIC SYSTEMS
TECHNOLOGY
KENNEWICK, WA USA
MADE IN USA
UHF Male
Connector
ANTENNA FEEDLINE
RECOMMENDATIONS
1. Up to 50 ft. use RG-8
Coax (EST P/N AA233).
2. Over 50 ft. call EST.
TNC Male
Connector
12 VDC POWER SUPPLY
RECOMMENDATIONS
EST P/N AA174
Battery Packs
2 Pin Molex
Connector
RS-232C
Setup
Switches
RS-232C, 422, & 485
Interface Connector
NOTES
1. Use coax cable runs as short
as practical to minimize cable
losses.
2. Vapor wrap all external
antenna coax connections with
vinyl wrap (EST P/N AA241) and
apply Scotchkote Electrical
Coating (EST P/N AA242).
3. Contact EST for
recommendations regarding
antenna mounting hardware and
installation tips.
4. For panel mounting the
ESTeem use mounting brackets
EST P/N AA251.
5. For panel mounting the AA174
power supply use mounting
brackets EST P/N AA252.
6. Ground antenna structure and
base.
RS-232C,422, or 485
INTERFACE CABLE
EST P/N AA06,
AA061, AA07, or
custom depending on
device.
Omni-Directional Antenna
Magnetic Mount. EST
P/N AA03 with 42 in.
vertical radial or P/N AA15
with 17 in. rubber duck
radial.
Note:
RG-8 feedline is
not required. Magnetic
mount antennas have
approximately 12 ft. of
integral RG-58 cable for
direct connection to
ESTeem.
Omni-Directional Antenna
Permanent Mount.
EST P/N AA04 with 42 in.
vertical radial or P/N
AA041 with 18 in. vertical
radial.
ANTENNA
RECOMMENDATIONS
User’s
Device