User`s manual

CHAPTER 4
ESTEEM APPLICATION PROGRAMS
4-6
3. TYPE FA <cr>. Please note the characters my not
be echoed by the crt.
ESTeem At Ph. Modem ESTeem At Terminal
---------------------------- ------------------------
ADD xxx ADD yyy
SETC yyy SETC xxx
XSF OFF XSF OFF
TERMC ON TERMC ON
TERMT 1 TERMT 1
DISACK ON DISACK ON
RTS_CTS ON RTS_CTS ON
DTR ON DTR ON
SETTRANS ON:SAVE SETTRANS ON:SAVE
SAVE SAVE
BIT 8 ON (RS-232 SWITCH) BIT 8 ON
RESET ESTEEM RESET ESTEEM
•
xxx and yyy represent an ESTeem address which is
user definable from 0 to 253.
Listed below is the RS-232 cable pin out:
ESTeem Hayes
ESTeem Laptop
1 ----- 1
2 ----- 3
3 ----- 2
20 ----- 6
22 ----- 20
7 ----- 7
25P TO 25P
2 ----- 3
3 ----- 2
4 ----- 7
5 ----- 8
6 ----- 6
7 ----- 5
8 ----- 1
20 ----- 4
22 ----- 9
25P TO 9P
CROSSTALK XVI INTERFACING
This application program is for an ESTeem interfaced to
a personal computer using CROSSTALK XVI. An
alternate to this application is using the Hayes emulation
mode in the ESTeem described in Chapter 2.
Perform the following prior to programming the
ESTeem(s) to initialize the unit to factory default
settings:
1. Turn Bit 8 OFF on the RS-232C Setup Switch.
2. Reset the ESTeem.
3. TYPE FA <cr>. Please note the characters my not
be echoed by the crt.
ESTeem At PC 1 ESTeem At PC 2
-------------------------- -------------------------
ADD xxx ADD yyy
SETC yyy SETC xxx
TERMC ON TERMC ON
TERMT 60 TERMT 60
SENDP 255 SENDP 255
PROMPT OFF * PROMPT OFF *
SAVE SAVE
BIT 8 ON *(RS-232 SWITCH) BIT 8 ON *
RESET ESTEEM RESET ESTEEM
•
Enable Bit 8 ON only if you want the
AUTO-CONNECT feature.
•
xxx and yyy represent an ESTeem address which is
user definable from 0 to 253.
NOTES:
1. In the CROSSTALK program set IN/OUT FILTERS
= OFF.
2. Type GO LOCAL at command.
3. Type SEND A: "file name".