User`s manual

CHAPTER 4
ESTEEM APPLICATION PROGRAMS
4-4
ESTeem At Mainframe ESTeem At Terminal
---------------------------- --------------------------
ADD xxx ADD yyy
SETC yyy SETC xxx
TERMC ON TERMC ON
TERMT 1 TERMT 10
DISACK ON * DISACK ON *
SENDP 255 SENDP 255
SETTRANS ON:SAVE SETTRANS ON:SAVE
BIT 8 ON (RS-232 SWITCH) BIT 8 ON
RESET ESTEEM RESET ESTEEM
•
Turn DISACK ON only if you want to defeat the
acknowledge packet.
•
You will probably have to connect a NULL Modem
adapter (reverse pins 2 & 3) between the DEC
11-780 and the ESTeem.
•
xxx and yyy represent an ESTeem address which is
user definable from 0 to 253.
HP-3000 EQUIPMENT
This program is used to connect a HP-3000 mainframe to
a HP-2392A terminal. This setup is a typical point to
point configuration with the AUTO-CONNECT feature
enabled.
Perform the following prior to programming the
ESTeem(s) to initialize the unit to factory default
settings:
1. Turn Bit 8 OFF on the RS-232C Setup Switch.
2. Reset the ESTeem.
3. TYPE FA <cr>. Please note the characters my not
be echoed by the crt.
ESTeem At Mainframe ESTeem At Terminal
-------------------------- ------------------------
ADD xxx ADD yyy
SETC yyy SETC xxx
TERMC ON TERMC ON
TERMT 1 TERMT 10
PROTOC ON
DISACK ON * DISACK ON *
SENDP 255 SENDP 255
SETTRANS ON:SAVE SETTRANS ON:SAVE
BIT 8 ON (RS-232 SWITCH) BIT 8 ON
RESET ESTEEM RESET ESTEEM
•
Turn DISACK ON only if you want to defeat the
acknowledge packet.
•
xxx and yyy represent an ESTeem address which is
user definable from 0 to 253.
NCR EQUIPMENT
This program is used to connect a NCR 3450 mainframe
to a NCR 4940 terminal. This setup is a typical point to
point configuration with the AUTO-CONNECT feature
enabled.
Perform the following prior to programming the
ESTeem(s) to initialize the unit to factory default
settings:
1. Turn Bit 8 OFF on the RS-232C Setup Switch.
2. Reset the ESTeem.
3. TYPE FA <cr>. Please note the characters my not
be echoed by the crt.
ESTeem At Mainframe ESTeem At Terminal
----------------------------- --------------------------
ADD xxx ADD yyy
SETC yyy SETC xxx
TERMC ON TERMC ON
TERMT 1 TERMT 5
DISACK ON * DISACK ON *
SENDP 255 SENDP 255
SETTRANS ON:SAVE SETTRANS ON:SAVE
BIT 8 ON (RS-232 SWITCH) BIT 8 ON
RESET ESTEEM RESET ESTEEM
•
Turn DISACK ON only if you want to defeat the
acknowledge packet.