User`s manual

CHAPTER 3
STARTING OUT
Revised: 27 Oct 08 3-6 EST P/N AA107G
4. Connect the Model 195Eg to your computer either direct to the Ethernet card or through a HUB/Switch using a CAT-5e
Ethernet cable. The Ethernet port on the 195Eg supports Auto-Negotiation so either a patch cable or crossover cable will
work. Open the ESTeem Discovery Program and press the Discover Modems button. The Model 195Eg will be displayed
in the program by the Ethernet MAC address and Current IP Address (Figure 7).
Note: The SSID and Mode of Operation will be adjusted later in the configuration.
5. Double-click on the 195Eg you want to program and the Configure IP Address window will be displayed (Figure 8). Enter
an IP address and Subnet Mask for the 195Eg that matches your network subnet and press the OK button to save this to the
ESTeem. You will receive notification that the Configuration was Successful and the 195Eg will reboot. Proceed to
ESTeem Setup in Chapter 4.
Figure 7: Discovery Program Main Page
Figure 8: Change IP Address Window