Instructions / Assembly

E-S 1000D Series Instruction Manual
Troubleshooting
5.16
 If the issue did not occur off the gate with P3 at 28:
PULL TO OPEN: Run the piston to the retracted position. Manually move the gate to the open
position. Swing the piston over to the gate bracket; if the piston is retracted too far to attach to
the gate bracket with the gate open, move the limit switch toward the center of the arm and
run the piston through another cycle. Repeat trying to attach to the gate in the open position
until the limit is stopping the piston at a point where when attached to the gate bracket the
gate is in the correct open position. Repeat this procedure with the piston extending and the
gate in the closed position.
PUSH TO OPEN: Run the piston to the extended position. Manually move the gate to the open
position. Swing the piston over to the gate bracket; if the piston is extended too far to attach to
the gate bracket with the gate open, move the limit switch toward the center of the arm and
run the piston through another cycle. Repeat trying to attach to the gate in the open position
until the limit is stopping the piston at a point where when attached to the gate bracket the
gate is in the correct open position. Repeat this procedure with the piston retracting and the
gate in the closed position.