Instructions / Assembly
E-S 1000D Series Instruction Manual
Troubleshooting
5.13
On thin gauge wires it is possible that the wire can get pinched and internally a split could
form. It would be very difficult to identify this from looking at the wire. To eliminate the wire
as an issue wire the receiver to the accessory terminals at the bottom following these in-
structions and a set of wires. You can use any wire, you will need 4 conductors. Remove the
existing wire AND the jumper wire:
a. First terminal on left, ANT - this is your antenna wire, this stays in place.
b. Second terminal from left, CH1 - connect this terminal to PUSH1 on the PUSH block.
c. Third terminal from left, CH1 - connect this terminal to COM on the PUSH block.
d. Fourth and fifth terminals from the left, CH2 and CH2 - these terminals will be left
empty.
e. Sixth terminal from left, V+ - connect this terminal to the V+ terminal on the PHOTO-
CELL block.
f. Last terminal on right, GND - connect this terminal to the GND terminal on the PHO-
TOCELL block.
Give a tug on all wires going into the receiver to make sure they are all making a good
connection. Also make sure the wire itself is connected in the terminal and not the colored
wire covering.
My accessory that is wired into the gate opener is no longer working
If the accessory is powered off the control board it could be a blown fuse. Otherwise it may be
the accessory and this can be confirmed using jumper contacts.
Fixes for the accessory is not working:
If the accessory is getting power from the gate opener, check the first fuse on the left side
of the control board. It is a 250V 2 Amp fuse. If the fuse is good but the accessory still does
not have power move the wire from the 12V terminal to the V+ terminal.
If it is a device that should be activating the gate there should be wires going to PUSH1 or
Push2 and Com. Remove these wires. Insert a short piece of wire into PUSH1 or PUSH2 and
Com. Momentarily contact those two wires together. If the gate opens the issue lies within
the accessory itself and the accessory should be replaced or troubleshot according to the
accessories instructions.
The battery continually reaches LU and is a solar installation
It is either not enough incoming power to charge the battery, the positioning of the panel or
the size of the battery.
Continue on next page.