Instructions / Assembly

E-S 1000D Series Instruction Manual
Troubleshooting
5.12
 There are two learn buttons at the top of the receiver. There is a Learn1 and a Learn2. The
wiring instructions provided in the manual are utilizing Channel1. Channel 1 is activated by
anything learned to the Learn1 button. Learn2 is pair to Channel2, which this channel is not
utilized in the instruction manual. Please consult estate swing if you wish to utilize Channel2
to activate a different device. To fix this error if you have programmed to Learn2 instead of
Learn1, first clear Learn2: Press and hold the Learn2 button, the learn light will illuminate,
continue to hold the Learn2 button until the learn light turns off.
Then follow the learn procedure for a remote on the Learn1 button.
 There is a white clip that attaches to the control board on the 5 pins on the right hand side
of the board. There are three wires in this clip red, white and green. On the board the clip
should be plugged in so the red wire is on the bottom.
The other end gets wired into the receiver. The wires and terminals should be as follows:
a. First terminal on left, ANT - this is your antenna wire, this stays in place.
b. Second terminal from left, CH1 - the green wire should be in this terminal.
c. Third terminal from left, CH1 - this terminal should have 2 wires, the white wire and also a
short jumper wire. After connecting both wires, give them a tug, with two wires in the termi-
nal it is possible that one may not be grabbed by the screw terminal.
d. Fourth and fifth terminals from the left, CH2 and CH2 - these terminals will be left empty.
Sixth terminal from left, V+ - the red wire should be in this terminal.
e. Last terminal on right, GND - the other end of the jumper wire should be connected to this
terminal.
 If the programming is correct and the wiring is correct but the remote will not activate the
gate, then the receiver plug should be checked. First check the fuse. The first fuse on the
left side of the board protects the receiver input plug. This is a 250V 2 amp fuse. Second you
can manually test the plug connector. Remove the white connector from the control
board to reveal the 5 prongs on the lower right hand side of the control board. Take a small
flat head screw driver and place the head between the second and third prong from the
bottom. Turn the head of the screw driver until a connection is made between the second
and third prong from the bottom. The gate should open if this terminal is working correctly. If
it does activate the gate then the receiver or the wire to the receiver is the issue, double
check all receiver related solutions.
Continue on next page.