User manual

eStarling TouchConnect User Manual 4
Physical Setup
(1) Attach the stand to the rear of the TouchConnect by screwing it into the threaded hole
clockwise in the back of the frame. Manually screw in the stand until it is tightened, but do not
over tighten. When facing the back of the frame in a horizontal position, the threaded hole is to
the left of the frame’s connections.
(2) Connect the power cord into the DC input of the TouchConnect and then plug the AC Adapter
into an AC wall outlet. Now you can press the power button on the back of the frame.
Secure Digital™ Card
When first setting up the frame, do not insert a Secure Digital™ Card (SD card) into the
eStarling TouchConnect. Once your frame is configured, you may insert an SD card into the SD
card slot. The eStarling TouchConnect will notify you that you are now in “SD Mode”. Your
normal photo gallery will be replaced with the photos on your SD card.
Please note that your normal photo gallery will not be accessible until you remove the SD card
from the SD card slot and re-enter “Internet Mode”. Also, the eStarling TouchConnect only
supports videos played in “Internet Mode”. It does not support videos in “SD Mode”.
Secure Digital™ Card Slot
Ethernet Connection
DC 12V
Power Button
Wall Mount
Stand