Owners manual

The print remains in the printer after printing has completed
The printer holds the paper to allow the print to dry after printing, see Change the drying time on page 60. If a
sheet of paper is only partially ejected after the drying time, gently pull it out of the printer.
The cutter does not cut well
By default, the printer is set to cut the paper automatically after each job.
If the cutter is turned on but not cutting correctly, check that the cutter rail is clean and clear of any
obstacles.
The roll is loose on the spindle
The roll may need to be replaced or reloaded.
154 Chapter 17 Troubleshooting paper issues ENWW