Owner`s manual

Troubleshooting
Problem
Failure to
start or no air
delivery
Possible Cause
1. No electrical power to
unit
Fuse blown
Circuit breaker
tripped
Electric cord un-
plugged or damaged
2. Belt too loose or tight
3. Motor overheated
Belt too tight
Blower bearings dry
4. Motor locked
Remedy
Check power
Replace fuse
Reset breaker
Plug in cords or
replace if damaged
2. Adjust belt tension
3. Determine cause of
overheating
Adjust belt tension
Oil blower bearings
4. Replace motor
Inadequate
air delivery
with cooler
running
1. Insufficient air exhaust
2. Belt too loose
3. Pads plugged
1. Open windows or
doors to increase air
flO_3."
2. Adjust belt tension or
replace if needed
3. Replace pads
Inadequate
cooling
Inadequate exhaust in
house
Pads not wet
Pads plugged
Open spots in pads
Trough holes
clogged
Pump not working
properly
Open windows or
doors to increase air
flO_3."
check water distribu-
tion system
Replace pads
Repack pads
Clean trough and
unplug holes
Replace or clean
pump (Unplug
unit)
Problem
Motor cycles
on and off
Possible Cause
Remedy
1. Low voltage 1. Check voltage
2. Excessive belt tension 2. Adjust belt tension
3. Blower shaft tight or 3. Oil or replace bear-
locked ings (Unplug unit)
4. Bearings dry 4. Oil bearings
Noisy 1. Bearings dry 1. Oil bearings
2. Wheel robbing blower 2. Inspect and realign
housing (Unplug unit)
3. Loose parts 3. Tighten loose parts
Excessive
humidity in
house
1. Inadequate exhaust 1. Open doors or win-
dows
Musty or
unpleasant
odor
1. Stale or stagnate water 1. Drain pan and clean
in cooler pads
2. Pads mildewed or 2. Replace pads
clogged
3. Pads not wetting 3. Check water distribu-
properly tion system
Trough holes Clean
clogged
Pump not working Replace or clean
properly pump (Unplug
unit)
Water drain- 1. Float arm not adjusted 1. Adjust float
ing from properly
cooler 2. Overflow assembly 2. Tighten nut and
leaking overflow pipe.
Limited Warranty
This warranty is extended to the original purchaser of an evaporative cooler installed and used under normal conditions. It does not cover damages incurred
through accident, neglect, or abuse by the owner. We do not authorize any person or representative to assume for us any other or different liability in con-
nection with this product.
Terms And Conditions Of The Warranty
For Eight Years from date of purchase, we will replace the original base assembly if water leakage should occur due to rust out.
For One Year from date of purchase, we will replace any original component provided by Champion Cooler which fails due to any defect in material or fac-
tory workmanship only.
Exclusions From The Warranty
We are not responsible for replacement of cooler pads. These are disposable components and should be replaced periodically. We are not responsible for any
incidental or consequential damage resulting from any malfunction.
We are not responsible for any damage received from the use of water softeners, chemicals, descale material, plastic wrap, or if a motor of a higher horsepower
than what is shown on the serial plate is used in the unit.
We are not responsible for the cost of service calls to diagnose cause of trouble, or labor charge to repair and/or replace parts.
For limited warranty to be valid the evaporative cooler must be maintained per the Maintenance Section of this manual.
How To Obtain Service Under This Warranty
Contact the Dealer where you purchased the evaporative cooler. If for any reason you are not satisfied with the response from the dealer, contact the Customer
Service Department: 5800 Murray Street, Little Rock, Arkansas 72209. 1-800-643-8341. Email: info@championcooler.com.
This limited warranty applies to the original purchaser only.
110496-1 5