Service manual

BEST ACCESS SYSTEMS
Indianapolis, Indiana
5 Making sure that the connector is properly
aligned, connect the outside wire harness
connector to the lower right circuit board
connector in the inside trim. Press firmly
on the connector until it is fully seated.
9 Secure the throughbolt
trim
1 Pull excess outside wire harness back
through to the outside.
2 Position the inside and outside trim onto
the door.
3 Making sure that the trim does not
pinch the wires, secure the trim to the
door — but do not tighten — with the
combination mounting screw at the top
mounting hole and with the standard
screw at the bottom mounting hole.
10 Connect battery pack
1 Connect the battery pack to the connector
hanging inside the battery compartment.
2 Insert the battery pack into the battery
compartment so that the foam will face
the battery door.
Caution: If installing a lock with the
turn knob function, make sure that the
battery wires are not rubbing against
the turn knob retaining ring.
11 Install battery compart-
ment door
1 Insert the tabs of the battery compartment
door into its mating slots and swing the
door closed.
2 Secure the battery compartment door with
the security screw. Tighten firmly.
12 Install inside and out-
side levers/knobs
For both levers and knobs
■ Unscrew the inside spindle one full turn to
allow the spindles to turn freely.
For levers
1 With the handle pointing toward the door
hinges, put the outside lever and spindles
into the lockset from the outside of the
door.
2 Slide the inside lever onto the inside spin-
dle and secure it with the set screw.
3 Tighten the trim mounting screws (see
Figure 12).
4 Turn the levers to check that they operate
smoothly.
For knobs
1 From the outside of the door, put the out-
side knob and spindles into the lockset.
2 Slide the inside knob onto the inside spin-
dle and secure with the set screw.
3 Push the set screw cap into the set screw
hole.
4 Tighten the trim mounting screws (see
Figure 12).
5 Turn the knobs to check that they operate
smoothly.
13 Install strike plate
1 Mortise the door jamb to accommodate
the strike box and strike plate. (See Instal-
lation Specifications or dimensions, tem-
plate V03 and H11.)
2 Insert the strike box into the mortise in the
door frame and secure the strike with
screws provided.
Figure 12
Figure 13
Combination
mounting
screw
Standard
mounting
screw
Battery
pack
Figure 14
Figure 15
Security
screw
Tabs
Set screw
Spindles
Figure 16
Figure 17
Set screw
Set screw
cap
3T61919/Rev C 1777873 ER-7991-1