Service manual

BEST ACCESS SYSTEMS
Indianapolis, Indiana
T61918/Rev B 1777831 ER-7991-1
5 Making sure that the connector is properly
aligned, connect the outside wire harness
connector to the lower-right circuit board
connector in the inside trim. Press firmly
on the connector until it is fully seated.
9 Secure the throughbolt
trim
1 Pull the excess outside wire harness back
through to the outside trim.
2 Position the inside and outside trim onto
the door.
3 Making sure that the trim does not
pinch the wires, secure the trim to the
door — but do not tighten — with the
combination mounting screw at the top
mounting hole and with the standard
screw at the bottom mounting hole.
10 Connect battery pack
1 Connect the battery pack to the connector
hanging inside the battery compartment.
2 Insert the battery pack into the battery
compartment so that the foam will face
the battery door.
11 Install battery
compartment door
1 Insert the tabs of the battery compartment
door into its mating slots and swing the
door closed.
2 Secure the battery compartment door with
the security screw. Tighten firmly.
12 Install inside and
outside knobs/levers
1 For the inside and outside levers
With the lever pointing toward the hinges,
push firmly on the lever until it is seated.
For the inside and outside knobs
Push firmly on the knob until it is seated.
2 Tighten the trim mounting screws (see
Figure 11).
3 Turn the knobs/levers to check that they
operate smoothly.
13 Install strike plate
Caution: The deadlocking plunger of
the latchbolt must make contact with
the strike plate, as shown in Figure 15.
The plunger deadlocks the latchbolt
and prevents someone from forcing
the latch open when the door is closed.
1 In alignment with the center of the latch-
bolt, mortise the door jamb to accommo-
date the strike box and strike plate.
2 Insert the strike box and secure the strike
with the two screws provided.
14 Install core and throw
member
1 Install the blocking plate onto the throw
member.
Caution: You must use the blocking
plate to prevent unauthorized access.
Figure 11
Figure 12
Combination
mounting
screw
Standard
mounting
screw
Battery pack
Figure 13
Figure 14
Security
Tabs
screw
Figure 15
Figure 16
Figure 17
Deadlocking
plunger
Strike plate
One-half door
thickness
Door stop
Door frame
Blocking plate
Throw member
3