Service manual

Security Device Maintenance

V Series Service Manual 2–39

To reinstall the inside and outside trim:

1. Holding the outside trim near its position on the door, feed the

outside wire harness back through the wire hole to the inside of the

door.

2. Reconnect the outside wire harness to the circuit board in the inside

trim. Reconnect the motor wire connector and deadbolt sensing

connector (for 30HV with deadbolt only).

Note: It is possible to plug the battery pack into the motor connector

and the motor wire into the battery connector. To avoid this,

connect only the connectors with matching wire colors.

3. Position the inside trim against the door and pull the outside wire

harness back through to the outside of the door until the wire

harness is taught.

4. Making sure that the trim does not pinch the wires, secure the

inside and outside trim to the door from the inside. Use the

combination mounting screw in the top mounting hole and the

standard screw in the bottom mounting hole. Do not tighten the

screws completely.

5. Reinstall the inside and outside knobs or levers.

6. Reconnect the battery pack.

7. Position the battery pack in the battery compartment.

8. Insert the tabs on the lower edge of the battery compartment door

into the battery compartment. Swing the door closed. Install the

security screw.

9. Tighten the trim mounting screws firmly.

Replacing the

wire harnesses

To replace the inside wire harness:

1. Open the battery compartment by removing the security screw and

the battery compartment cover.

2. Remove the battery pack from the battery compartment.

3. Disconnect the battery pack.

4. Remove the inside knob or lever.

5. From the inside of the door, remove the upper and lower

escutcheon screws and pull the inside trim out enough to expose

the circuit board. Carefully disconnect the outside wire harness

from the circuit board. Disconnect the motor connector and the

deadbolt sensing connectors (30HV with deadbolt only).

6. Unfasten the coin–cell battery from the inside trim.

7. Release the wires from the wire clamp on the inside trim.