Service manual

Security Device Maintenance
2–38 V Series Service Manual
4. Position the new battery pack in the battery compartment.
5. Insert the tabs on the lower edge of the battery compartment door
into the battery compartment. Swing the door closed. Install the
security screw.
Removing and
reinstalling the
inside and
outside trim
To remove the inside and outside trim:
Refer to Figure 2.18 and follow the steps below.
1. Open the battery compartment by removing the security screw and
the battery compartment cover.
2. Remove the battery pack from the battery compartment.
3. Disconnect the battery pack.
4. Remove the inside knob or lever.
5. From the inside of the door, remove the upper and lower
escutcheon screws and pull the inside trim out enough to expose
the circuit board. Carefully disconnect the outside wire harness
from the circuit board. Disconnect the motor connector and the
deadbolt sensing connector (30HV with deadbolt only).
6. Set aside the inside trim.
7. Feed the outside wire harness to the outside of the door through the
wire hole in the door.
8. Remove the outside knob or lever.
Note: For 8V and 9V, remove the core and depress the knob keeper
with a screwdriver blade.
9. Remove the outside trim.
Figure 2.18 Removing the inside trim
Motor connector
Deadbolt sensing connector
Inside trim
Circuit board
Outside wire harness
Wire hole in the door