Instruction manual

19
Essex Electronics, Inc. | 805.684.7601 | 800.KEY-LESS | fax [phone] | keyless.com
2. Wait ve seconds for the 3 reset beeps. (Do not enter any digits
until you hear 3 reset beeps.)
 Programming Door Open Time
Default a 5 seconds
To Program/Change the Door Open Time for the Master Code and
User Code 1 and 2:
1. First determine the length of time you wish to program as the
Door Open Time for these users. This is the length of time the
door will remain open after a valid Master Code, User Code 1 or
User Code 2 has been entered into the system.
Note: For controlling a garage door or electric gate, you will need
to set the door open time to 1 second
2. Locate the Control Module, remove the cover and locate the
“PROGRAM” switch on the circuit board.
3. Press the PROGRAM switch once *. (The Keypad will beep
rapidly 4 times.)
4. At the Keypad, enter 1-1-1-7 to open the memory (you will hear
three rapid beeps) and enter a combination of “1’s” (for every one
second increment) and “5’s” (for every ve second increment)
that equal your desired Door Open Time. Each valid key press (a
“1” or a “5”) will generate a double beep. (Do not let more than
ve seconds elapse between entries or the system will reset!!!
Example: “1-1-1-7 5-5-5-1-1” a 17 seconds
5. After entering your Door Open Time, wait ve seconds for the 3
reset beeps.
To Program/Change the Door Open Time for User Code 3, 4, and 5
(Rev B and later):
1. First determine the length of time you wish to program as the
Door Open Time for these users. This is the length of time the