User manual

Press or turn the knob for the
temperature to start the pyrolysis.
You can use the END function to delay the
start of the cleaning.
During the pyrolysis the oven lamp is off.
5. When the oven is at the set
temperature, the door locks. The
display shows and the bars of the
heat indicator until the door unlocks.
To stop pyrolysis before it is
completed, turn the knob for the oven
functions to the off position.
6. When pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
7. When the oven is cool again, the door
unlocks.
Cleaning reminder
To remind you that the pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the oven.
The cleaning reminder goes
out:
• after the end of the
pyrolysis.
• if you press and at the
same time while PYR
flashes in the display.
Removing and installing door
The oven door has four glass panels. You
can remove the oven door and the internal
glass panels to clean them. Read the
whole "Removing and installing door"
instruction before you remove the glass
panels.
The oven door may close if you
try to remove the glass panels
before you remove the oven
door.
CAUTION! Do not use the
oven without the glass panels.
1. Open the door fully and hold both
hinges.
2.
Lift and turn the levers fully on both
hinges.
3. Close the oven door halfway to the first
opening position. Then lift and pull
forward and remove the door from its
seat.
29