User manual

Stainless steel or aluminium
ovens
Clean the oven door with a damp cloth or
sponge only. Dry it with a soft cloth.
Do not use steel wool, acids or abrasive
materials as they can damage the oven
surface. Clean the oven control panel with
the same precautions.
Removing the shelf supports
To clean the oven, remove the shelf
supports.
CAUTION! Be careful when
you remove the shelf supports.
1. Pull the front of the shelf support away
from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove it.
2
1
Install the removed accessories in the
opposite sequence.
The retaining pins on the
telescopic runners must point
to the front.
Pyrolysis
CAUTION! Remove all
accessories and removable
shelf supports.
Do not start the Pyrolysis if you
did not fully close the oven
door. In some models, the
display shows "C3" when this
error occurs.
WARNING! The oven becomes
very hot. There is a risk of
burns.
CAUTION! If there are other
appliances installed in the
same cabinet, do not use them
when the Pyrolysis function
operates. It can cause damage
to the appliance.
1. Wipe out the cavity with a wet, soft
cloth.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Set the Pyrolysis function. Refer to
"Daily use" chapter, "Oven Functions".
4. When
flashes, press or to
set the pyrolysis duration:
Option Description
P1 Light cleaning.
Duration: 1 h.
P2 Normal cleaning.
Duration: 1 h 30
min.
Press or turn the knob for the
temperature to start the pyrolysis.
You can use the END function to delay the
start of the cleaning.
During the pyrolysis the oven lamp is off.
5. When the oven is at the set
temperature, the door locks. The
display shows and the bars of the
heat indicator until the door unlocks.
To stop pyrolysis before it is
completed, turn the knob for the oven
functions to the off position.
25