User manual

Removing the shelf supports
and removing the catalytic
panels
To clean the oven, remove the shelf
supports and remove the catalytic panels.
CAUTION! Be careful when
you remove the shelf supports.
The catalytic panels are not
attached to the oven walls and
can fall out when you remove
the shelf supports.
1. Pull the front of the shelf support away
from the side wall. Hold the rear shelf
runners and catalytic panel in place
with the other hand.
2. Pull the rear end of the shelf support
away from the side wall and remove it.
2
1
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must point
to the front.
Catalytic cleaning
CAUTION! Do not clean the
catalytic surface with oven
sprays, abrasive cleaning
agents, soap or other cleaning
agents. This will damage the
catalytic surface.
Spots or discolouration of the
catalytic surface have no effect
on catalytic properties.
WARNING! Keep children
away when you clean the oven
at a high temperature. The
oven surface becomes very hot
and there is a risk of burns.
Before activating the catalytic
cleaning remove all the
accessories from the oven.
The walls with a catalytic coating are self-
cleaning. They absorb fat which collects
on the walls while the appliance operates.
To support the self-cleaning procedure,
heat the empty oven on a regular basis.
1. Clean the oven floor with warm water
and washing up liquid, then dry it.
2. Set the function .
3. Set the oven temperature to 250 °C
and let the oven operate for 1 hour.
4. When the appliance is cool, clean it
with a soft and moist sponge.
Cleaning the oven door
The oven door has three glass panels.You
can remove the oven door and the internal
glass panels to clean them.
The oven door can close if you
try to remove the glass panels
before you remove the oven
door.
CAUTION! Do not use the
appliance without the glass
panels.
1. Open the door fully and hold the two
door hinges.
21