User manual

1. Install the anti-tilt protection 232 - 237
mm down from the top surface of the
appliance and 110 - 115 mm from the
side of the appliance into the circular
hole on a bracket. Screw it into the
solid material or use applicable
reinforcement (wall).
110-115
mm
232- 237
mm
2. You can find the hole on the left side at
the back of the appliance. Lift the front
of the appliance and put it in the
middle of the space between the
cupboards. If the space between the
bench cupboards is larger than the
width of the appliance, you must adjust
the side measurement to centre the
appliance.
If you changed the dimensions
of the cooker, you must align
the non-tip device correctly.
CAUTION! If the space
between the bench cupboards
is larger than the width of the
appliance, you must adjust the
side measurement to the
centre of the appliance.
Electrical installation
WARNING! The manufacturer
is not responsible if you do not
follow the safety precautions
from Safety chapters.
This appliance is supplied without a main
plug or a main cable.
WARNING! Before you
connect the mains cable to the
terminal, measure the voltage
between phases in the house
network. Then, refer to the
connection label at the back of
the appliance to use the correct
electrical installation. This order
of steps prevents from
installation errors and damage
to the electrical components of
the appliance.
WARNING! The power cable
must not touch the part of the
appliance shaded in the
illustration.
8