User manual

Problem Possible cause Remedy
and a number come on.
There is an error in the hob. Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an Authorised Service
Centre.
comes on.
There is an error in the hob
because a cookware boiled
dry. Automatic Switch Off
and the overheating protec‐
tion for the zones operate.
Deactivate the hob. Remove
the hot cookware. After ap‐
proximately 30 seconds, ac‐
tivate the zone again. If the
cookware was the problem,
the error message goes out.
Residual heat indicator can
stay on. Let the cookware
become sufficiently cool.
Check if your cookware is
compatible with the hob.
Refer to “Hints and tips”
chapter.
The oven does not heat up. The oven is deactivated. Activate the oven.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation
settle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
The oven does not heat up. The clock is not set. Set the clock.
The oven does not heat up. The necessary settings are
not set.
Make sure that the settings
are correct.
It takes too long to cook the
dishes or they cook too
quickly.
The temperature is too low
or too high.
Adjust the temperature if
necessary. Follow the ad‐
vice in the user manual.
The display shows an error
code that is not in this table.
There is an electrical fault. Deactivate the oven with the
house fuse or the safety
switch in the fuse box and
activate it again.
If the display shows the er‐
ror code again, contact the
Customer Care Department.
The display shows "12.00". There was a power cut. Reset the clock.
31