Installation guide

Step 10: Eject Pen Drive
Once the appropriate settings have been entered hit the ‘Finish’ button to close the wizard. Follow
the given instructions on how to safely eject the USB Pen from the computer.
Step 11: Apply Configuration to Encoder
Transferring the settings from the USB Pen Drive to the Network Encoder is a process that must be
performed when the Network Encoder is powered on.
1. Plug the USB Pen Drive into the USB Socket on the Encoder.
2. If the Encoder is being configured to use the 3G modem then insert the mobile network SIM card
into the SIM slot on the front panel of the Encoder. Remember to close the SIM Lock.
3. Power the Network Encoder.
4. Watch the Status Lights - the sequence should be:
If all the status lights stay red indefinitely then there was an error transferring the settings to the
Network Encoder. Power the Network Encoder down, plug the USB Pen Drive back into your PC
and check that the settings entered were correct.
Step 12: Reset Encoder
1. Remove the USB Pen Drive.
2. After a few seconds the Encoder will reset itself.
3. The Encoder should now attempt to connect to the TVI Server.
Boot Process
When powered the Encoder will move through each of the following light sequences:
Status Lights Colour Approx Time Indicates
Power Only (green) 10 seconds Powering up and booting
Animated orange lights 5 seconds Performing update
All status lights solid green Indefinitely Update completed successfully
All status lights solid red Indefinitely Update failed
Status Lights Colour Indicates
Flashing orange IP-Link Initialising connection
Flashing green IP-Link (3G Only) connecting to Network
Solid green IP-Link Connection successfully created
Flashing orange Server-Link Connecting to Server
Flashing green Server-Link Handshaking with Server
Solid green Server-Link Successfully connected to Server