Installation guide

Step 4: Encoder Name and Server Address
Step 5: Encryption and Authentication
Standard LAN (RJ45) Connection The Encoder will connect to any network / device that
presents a standard LAN interface.
Internal 3G Modem The Encoder has a built in 3G modem for mobile
communication that supports HSDPA, 3G, EDGE and
GPRS.
Hughes Inmarsat BGAN Terminal The Encoder has special support built-in for Hughes
Inmarsat BGAN Terminals.
Thrane & Thrane / The Encoder has special support for Thrane & Thrane
Standard LAN BGAN Terminal BGAN Terminals.
Serial Port The encoder has support for serial port transmission
which is beyond the scope of this document.
See the separate ‘Serial Radio Configuration’ guide.
Encoder Name
Each TVI Encoder requires an account be created on
your TVI Server (using TVI Manager). Please refer to
the TVI Manager Guide for instructions on how to
create Encoder accounts.
Enter the name of the Encoder account that was
created for this Encoder.
TVI Server Address
Enter the IP Address or Domain Name that the
Encoder will use to communicate with the Server.
This can either be an IP Address (e.g. 12.87.54.255)
Encoder Password
Enter the password that was assigned to the Encoder
account.
Encryption
If Encryption support is enabled on your TVI Server all
communication between the Encoder and Server can
be encrypted by enabling ‘Encrypt the link between
Encoder and Server’. Use of this feature requires the
Encryption Pack (refer to the TVI Server Guide for
further details).