Hardware manual

TVI I300 Hardware Manual © Essential Viewing Systems Limited 2010
Page 7
4.1 Connector Parts
The following parts are required for connection to the I300 board. Note that wires must not be
soldered directly to any pins on the board.
Part Quantity Port(s)
50 ohm SMA plug 1 Cellular RF
Mini SMB 75ohm plug (RG-179 cable)
Amphenol: 903-586P-71A
Tyco Electronics: 5415484-1
3
2 x video in
1 x Video out
JST, PHR connector
PHR-5
(24 to 28 AWG cable)
1 Audio
JST, PHDR connector
PHDR-08VS
(24 to 28 AWG cable)
3
Ethernet
Status LEDs
Ext. SIM
JST, PHDR connector
PHDR-10VS
(24 to 28 AWG cable)
5
USB 2.0
RS232
RS422
SSI
Status LEDs
Molex
43025-0200
(24 AWG cable)
1 Power
JST – (Crimp connector for all parts
except power)
SPHD-002T-P0.5
75
1 x PHR-5
3 x PHDR-08VS
5 x PHDR-10VS
Molex – (Crimp for power)
43030-0007
2 Power