Hardware manual

TVI I300 Hardware Manual © Essential Viewing Systems Limited 2010
Page 5
3 Mechanical Dimensions
The TVI I300 PCB is 120mm long by 145mm wide by 1.6mm deep. The board incorporates six
M3 sized grounded holes to support mounting of the board within an enclosure. The mounting
points are specified by the following diagram where all dimensions are in mm and the view is of
the top side of the board.
Note that when using the mounting holes, an M3 flat washer must be used on both sides of the
board where the washer must have a diameter no greater than 7mm.
The I300 board includes a SIM carrier to support cellular operation where this is mounted at the
front of the board extending the length by 7mm to 127mm.