Owner Manual

Draining Your Spa
Your spa should be drained every 3-4 months, and
refilled with fresh tap water. The following is the rec-
ommended method for draining your spa.
1. Turn off the power at the breaker.
2. Remove filter.
3. Your drain valve is located inside the spa cabinet
on the Service Access Side.
4. Locate hose ending with the 3/4 inch hose shut-off
valve.
5. Hook up the female end of a garden hose to the
drain fitting.
6. Place the other end of the garden hose where you
would like the water to drain to.
7. Twist the hose shut-off valve counterclockwise to
open the drain.
8. Let spa drain completely, then remove garden
hose.
9. Twist the hose shut-off valve clockwise to close it
and replace cap.
Water drained from your spa is safe to dispose of in your
yard, septic system or in a drain. Follow all local/municipal
codes and regulations for disposal.
__________________________________________
Cleaning Your Spa
Resin Spa Surface
For normal care and cleaning, use a soft cloth or
sponge with soap and water. Rinse well and dry with
a soft, clean cloth.
• Clean grease, oil, paint and ink stains with isopropyl
(rubbing) alcohol. Rinse well and dry with a soft,
clean cloth.
• Never use abrasive cleaners.
• Do not allow your surface to come into contact
with nail polish, nail polish remover, wintergreen oil
(methyl salicylate), dry cleaning solution, lacquer
thinners, gasoline, pine oil, etc.
Avoid placing razorblades or other sharp instru-
ments on this surface as they may scratch it. Small
scratches can be removed by buffing lightly with a
clean cloth and using either an automotive polishing
liquid or a toothpaste containing a fine polishing in-
gredient. For deeper scratches, sand the surface
lightly with 400 grit “wet or dry” paper and buff with
fine-grit buffing compound.
Spa Cover and Pillows
Protect spa cover and pillows by
applying a spa vinyl cleaner as part
of your monthly maintenance
plan. It is specifically designed to
protect spa covers and pillows from chemical and ul-
traviolet light damage without leaving an oily residue
behind.
Warning: Do not use automotive vinyl protectants on spa
covers or pillows. These products are generally oil-based
and will cause severe water clarity issues that are difficult
to correct.
Removing and Reseating Pillows
You can remove the pillows for cleaning and mainte-
nance quickly and easily. This method works for all
types of pillows.
To attach rectangular pillows:
1. Hold pillow LOWER than the final pillow position.
2. Drag the pillow UPWARD allowing the BOTTOM
of the bracket to enter the slot in the pillow first.
3. As the pillow begins to attach to the bracket,
press inward on the center of the pillow.
4.The pillow will snap into place.
__________________________________________
22
Maintaining Spa Water Quality/Cleaning and Care
1. 2.
3. 4.