Owner Manual
18
Operate Your Spa
s
hould overlap the usage time by a half
hour. This will have spa temperature closest
to the desired temperature.
a. Example, if using the spa at 8:00 have spa
filter from 6:30 – 8:30.
4. Best used in mild to warm climates
5. Tests show a 20% reduction in energy con-
sumption when compared to standard
mode
d. Sleep – Sl
i. Sleep is considered a vacation heater setting,
and will maintain your spa water at the most
affordable price
1. Spa will only heat during your filter period
2. The water temperature may drop up to 20
degrees below your desired temperature
3. Will work in all climates, and will not allow
the spa to freeze
4. Tests show a 50%+ reduction in energy con-
sumption when compared to standard
mode
4. Steam Loss / Venting Around Spa Cover
a. It is normal to see an occasional burst of steam
from around the cover due to pressure releasing
from a high to low area. However heat loss can be
greatly impacted by use of the spa
i. Control valves should be turned off when
getting out of the spa in a cool climate.
1. Air injects from the cabinet and enters into
the water area. That air not only will cool
the cabinet area, but will also greatly in-
crease the pressure under the cover and
cause more steam to release.
ii. Surfaces are different for all spas, and cov-
ers may provide a better seal is spun differently.
1. If the folding seam goes over the controller
area, often more steam will be able to es-
cape. Try to position the cover so that the
fold seam goes over the wider top surface
areas on the adjacent sides.
Proper Spa Cover Use
Important! Keep the spa covered when not in use!
• Covered spas will use less electricity in maintaining
your set temperature.
• Covering your spa will protect your spa’s finish
from the sun’s ultraviolet rays.
• You are required to keep the spa covered to main-
tain warranty coverage.
•
Covering your spa helps prevent children from
drowning in the spa. See the photo for instructions
on mounting the locks and how to lock and unlock
the cover.
• In addition, while a soft spa cover is rigid, it is not
designed to support any weight. Therefore, as a
safety precaution and to preserve the life of your
cover, you must not sit, stand, or lie on it, nor
should you place objects of any kind on top of it.
__________________________________________
Personal Settings
Jets
Jets in your spa may be ad-
justable. Rotating the face of an
adjustable jet to the left
(counter-clockwise) will increase
the amount of water flow
through the jet. Rotating the face of an adjustable jet
to the right (clockwise) will decrease the amount of
water flow through the jet.
Air Controls
Air controls are
the 2” knobs
located around
the top of your
spa. Each one
will let you add
a mixture of air with the jet pressure. This is accom-
plished by rotating the air control knob to the left
(counterclockwise) to increase the amount of air-
flow through the jets. To decrease the amount of air-
flow through the jets, rotate the handle to the right
(clockwise).
Water Feature Controls (if equipped)
Some spas in-
clude water-
falls
and/orwater
columns. In-
crease or de-
crease the flow of the waterfall using the 2” water
on/off knob nearest the water feature.