Owner Manual
16
Operate Your Spa
Topside Control Panels
System Settings
When your spa is first actuated, it will go into Prim-
ing mode, indicated by “Pr.” The Priming mode will
last for less than 5 minutes (press a Temperature
button to skip Priming Mode) and then the spa will
begin to take temperature readings, followed by the
heater test cycle. After completed, the heater will
turn on, heat the spa and maintain the water tem-
perature in the Standard mode.
The start-up temperature is set at 100°F/37°C.
The last measured temperature is constantly dis-
played on the LCD. Note that the last measured
spa temperature displayed is current only when the
pump has been running for at least 2 minutes.
Maximum Temperature is set at 104ºF/40ºC
as required by UL/CSA.
Minimum temperature is 80ºF/26ºC.
Note: If the spa is currently in a heating or filtration
cycle the primary pump will only switch between high
and low. It cannot be turned off until the heating or fil-
tration cycle is completed.
Preset Filter Cycles
The first filter cycle begins 6 minutes
after the spa is energized. The sec-
ond filter cycle begins 12 hours later.
The default filter time is 2 hours. Recommended
setting is F2.
Example: In a 12 hour period (1 cycle), a setting of F2
means 2 hours of filtration on, 10 hours of filtration off.
You may choose F2, F4, F6, F8 or c (continuous).
To program, press a temperature button, then “Jets”.
Press a temperature button to adjust. Press “Jets” to
exit.
Mode
Mode is changed by pressing a temperature button,
then pressing the “Light” button.
Standard Mode is programmed to maintain the
desired temperature. Note that the
last measured spa temperature dis-
played is current only when the pump
has been running for at least 2 minutes. “ST” will be
displayed momentarily when you switch into Stan-
dard Mode. The temperature is constantly displayed
when in Standard Mode. This is the best mode to
use during COLD weather.
Economy Mode heats the spa to the set temper-
ature only during filter cycles or if the
temperature falls to 20 degrees
below set temperature. “EC” will dis-
play solid when temperature is not current, and will
alternate with temperature when temperature is
current. This is the best mode to use during WARM
weather.
Sleep Mode heats the spa to the set temperature
only during filtration cycles. “SL” will
display solid when temperature is not
current, and will alternate with tem-
perature when temperature is current, but only
within 20 degrees of your set temperature.
Freeze Protection
If the temperature sensors detect a drop to below
44°F/6.7°C within the heater, the pumps will auto-
matically activate to provide freeze protection. The
equipment stays on until 4 minutes after the sensors
detect that the spa temperature has risen to
45°F/7.2°C or higher.
__________________________________________
One-Pump Spas
Jets
Touch the “Jets” button once to turn the main
2-speed pump on or off, and to shift between low
and high speeds. If left running, the low speed of the
pump will automatically turn off after 2 hours, and
the high speed will automatically turn off after 15
minutes.
Lights
Press the Light button on the topside control panel
to turn the spa light on. If your spa has perimeter
LED lights, they will also light up at the same time as
the spa light. LEDs operate in four modes. The mode
is changed by turning the light off and then immedi-
ST
Ec
SL
F 2