User`s manual

9/28/2007 VoIP Phone Administration Guide MAG-07005-2 Rev. D
to the ADSL Router, or Broadband Router. Also, you can use PPPoE to get the WAN IP address from
your ISP.
The default setting is Bridge mode. If you don’t need to use the Bridge mode, you can change to NAT
mode.
The WAN port default is DHCP Client mode. You can change the setting to Fixed IP mode, or PPPoE
mode.
If you change the WAN port’s setting to Fix IP mode, then you have to make sure the IP address. Net
Mask, Gateway, and DNS settings are suitable in your current network environment.
Host Name: Name of the phone. The information can be transmitted in a packet.
If you change the WAN port’s setting to PPPoE mode, you have to input a correct username/password
to get the IP address from your Internet Service Provider.
Service Name: Name of the server. You can contact your SIP provide for the information.
When you have finished the settings, click Submit. Go to the Save Changes page and click Save to
reflect the changes.
Note: When selecting DHCP Client and cannot detecting the IP, the IP Phone will provide a default IP,
192.168.2.25.
3.5.3 LAN Settings
In this page, you can configure the VoIP Phone LAN port’s setting.
20