User`s manual

9/28/2007 VoIP Phone Administration Guide MAG-07005-2 Rev. D
3 Setup the VoIP Phone by Web Browser
Default the IP Phone’s Bridge is enabled, WAN port is in DHCP Client Mode. LAN port is the same as
WAN. Connect the VoIP Phone to DHCP server, and the server assign an IP address to the phone.
Check the IP address and add the port number “:9999” at the end of the IP address to access the web
browser.
Note: When selecting DHCP Client and cannot detecting the IP, the VoIP Phone will provide a default
IP, 192.168.2.25.
Note: It is highly recommended to use Internet Explorer 6.0 or later for web configurations.
3.1 Login
Please input the username and password into the blank field. The default setting is:
1. For Administrator, the username is: root; and the password is: test. If you use the account login,
you can configure all the setting.
2. For normal user, the username is: user; and the password is: test. If you use the account login,
but you can not configure the SIP setting.
Click Login to move into the VOIP PHONE web based management information page.
Any changes in the Web Management interface except for Phone Book require clicking Submit in that
page, and then go to the Save Changes page and click Save. The system will restart, and all the
settings can work properly.
3.2 System Information for the VoIP Phone
When you login the web page, you can see the current system information of the VoIP Phone like
Model Name, Firmware Version, Vendor ID and Codec Version in this page.
Also you can see the function lists in the left side. You can use mouse to click the function you want to
set up.
9